|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Sono molto soddisfatto e, quando mi necessiterà, mi avvarrò nuovamente di questo servizio!
;
A comprehensive Operating and Service Manual. All schematics are complete and easy to read. The PCB drawings and complete parts list are very helpful. I would definitely recommend this manual.
;
SCANNING OF HIGH QUALITY
VERY, VERY HIGH VELOCITY DOWNLOAD
VERY GOOD PRICE,
TRUE SATISFIED, THANKS
;
Genuine Toshiba owner's manual. Couldn't really ask for more. And written in understandable English in contrast to a few recent experiences I have had with manuals for other equipment other than Toshiba but made in China and written in "Chinglish"!
;
I purchased a vintage Sony mixer off eBay and within the hour was able to locate and purchase the manual for it.I mean really,where else can you find a manual for a product made in 1983!? It was easy to find and purchase/download the manual I needed.I will use this site again for other equipment I have! Great site!
Door reversibility
Remove the two screws which �x the upper hinge to the door. Carefully lean the appliance on its back and remove the plastic insert (Fig. 4).
Fig. 4
Fitting a decorative door panel
Important: The components needed to �t the decorative panel have been pre-�tted on the appliance. The brackets are secured to the panel by means of the 7 � 3.5x13 screws supplied. Before starting to �t the panel, remove the large top bracket by unscrewing the screws and adjusting pins pre-�tted on the appliance door. The small bottom bracket need not be removed. Place the appliance in the position where it is to be built in (Fig. 6). The appliance is �tted with adjustable feet; screw the front and rear feet in or out to adjust the height of the appliance to that of the recess. Keeping the appliance central in the recess, slide it in until its back touches the wall.
D447
Fig. 6
Remove the two screws which �x the lower hinge to the door. Remove the four screws which �x the lower hinge to the base of the appliance and remove the hinge itself; be very careful to recover all the screws. Remove the four screws that �x the upper hinge to the appliance and remove the hinge itself. Take the hinge removed from the upper part of the appliance on the opposite side (see Fig. 5), and, using the screws removed from the lower part, �x it to the base of the appliance itself. Remove and re�t the other hinge on the upper part of the appliance on the opposite side.
Fig. 5
D467
A
= =
With a tape measure (or similar instrument), measu re d i s t a n c e ( A ) between the top edge of the door and the top edge of the decorative panel, placing it next to the recess.
Fig. 7
Lay the panel face down (Fig. 7). Position the top bracket on the panel, making sure that there is an equal distance between it and the sides and
Fix the two front s c re w s i n t o t h e upper and lower hinges (Fig. 5).
=
=
A
-1cm
D510
Finally, check the alignment of the door and make sure it closes properly. After having reversed the opening direction of the door, discard the original plastic insert removed and �t the insert supplied with the appliance on the opposite side.
that its distance from the top edge D468 is equal to distance (A) less 1 cm. Secure the bracket with the screws supplied. Take care not to damage the front face of the panel whilst working.
Fig. 8
B
Insert the adjusting pins (B-Fig. 8) into their locations in the door and screw them in.
D532
6
|
|
|
> |
|
